10
TASCAM MZ-372
y
PFL switches/indicators
o
When a
PFL
switch is on (
PFL
indicator lit), the
pre-fader signal (signal before fader adjust-
ment) can be monitored through headphones.
o
When a
PFL
switch is off, only the normal mon-
itoring sound is output.
u
MIXING knob
Use this to mix the pre-fader and monitoring sig-
nals output to the headphones.
o
Turn all the way to the
PFL
side to monitor
channels that have their
PFL
(
y
) switches
pressed in.
o
Turn all the way to the
MONITOR
side to moni-
tor the monitoring signal.
i
PHONES VOLUME knob
Use this to adjust the headphone output level.
o
L/R SPLIT switch/indicator
Press to change the headphone output mode.
o
When the
L/R SPLIT
switch is on (indicator lit),
pre-fader signals are output from the left chan-
nel and the monitoring signal is output from
the right channel.
o
When the
L/R SPLIT
switch is off (indicator un-
lit), the monitoring signal is output. When
PFL
switches are on, the pre-fader and monitoring
signals are mixed and output together.
NO
The PFL signals are mixed with the monitoring sig-
nal, so the selected PFL signals will sound louder.
p
PHONES jack
Use this standard stereo jack to connect stereo
headphones.
Use an adapter to connect headphones with a mini
plug.
The monitoring and PFL signals can be monitored,
depending on the
PFL
(
y
) and
L/R SPLIT
(
o
)
switch settings.
Rear panel
a
POWER switch
Press to turn the unit on and off.
When on, the
POWER
(
9
) indicator lights on the
front of the unit.
s
MONITOR OUT mic mix switch
This sets whether or not the input signal from a mic
connected to the
MAIN MIC INPUT
(
w
) jack on the
front of the unit is sent to and mixed with the mon-
itoring output.
To mix the input signal from a mic connected to
the
MAIN MIC INPUT
(
w
) jack with the monitoring
output, set the
MONITOR OUT
mic mix switch to
WITH MIC
.
d
SUB OUTPUT switch
Set whether the output from the
SUB OUTPUT
(
x
)
jacks is stereo or mono.
Set it to
MONO
for mono output.
f
MAIN OUTPUTS 1-2 (UNBALANCED) jacks
These analog outputs are RCA pin jacks.
Use the
ATTENUATOR
(
g
) switch to change the
output level.
g
ATTENUATOR switches
These switch the output levels from the
MAIN
OUTPUTS 1-2 (UNBALANCED)
(
f
) and
MAIN
OUTPUTS 1-2 (BALANCED)
(
c
) jacks.
Set them to
OFF
if the destination amplifier re-
ceives high gain, and set it to
ON (-6dB)
if the des-
tination amplifier receives low gain.
