Tascam AV-452, Инструкция по установке и поддержке

Страница: 19 / 24

7 – External control
TASCAM AV-452 Installation & Support Guide
19
IR “blaster”
Note that pin 21 (and pin 2, +5V) may be connected
to an IR “blaster” device, which can be used to relay
command codes from the AV-452 to an external mon-
itor or projector, etc.
The procedure for learning these command signals is
described in "LEARN IR (switch 1)" on page 16.
An IR blaster that has been found to work well with
the AV-452 is the Xantech 283M IR emitter. Please
consult your TASCAM distributor for up-to-date de-
tails of other suitable units that can be used with your
AV-452.
RELAY CONTROL pinouts
Pin # Signal Meaning Pin # Signal Meaning
1 GND GND 20 NC
2 +5V +5V (50 mA maximum) 21 IR OUTPUT Connect the wired IR remote device
3 MIC 1 MUTE Turns the MIC 1 MUTE on and off 22 MIC 1 MUTE Tally
4 MIC 2 MUTE Turns the MIC 2 MUTE on and off 23 MIC 2 MUTE Tally
5 MIC 3 MUTE Turns the MIC 3 MUTE on and off 24 MIC 3 MUTE Tally
6 MIC 4 MUTE Turns the MIC 4 MUTE on and off 25 MIC 4 MUTE Tally
7 A/V DIM Turns the AV DIM on and off 26 A/V DIM Tally
8 CASSETTE Selects Cassette as the AV source 27 CASSETTE Tally
9 RGB 1 Selects RGB 1 as the Projector or RGB monitor source 28 CD-RW Tally
10 RGB 2 Selects RGB 2 as the Projector or RGB monitor source 29 DVD Tally
11 CD-RW Selects CD-RW as the AV source 30 VCR Tally
12 DVD Selects DVD as the AV source 31 AUX IN Tally
13 VCR Selects VCR as the AV source 32 RGB 1 Tally
14 AUX IN Selects AUX IN as the AV source 33 RGB 2 Tally
15 AMP A Turns the AMP A output on and off 34 AMP A Tally
16 AMP B Turns the AMP B output on and off 35 AMP B Tally
17 INTERCOM Activates the INTERCOM input 36 INTERCOM Tally
18 CASCADE Activates the CASCADE input 37 VOLUME DOWN Volume down
19 VOLUME UP Volume up
1
2
3
4
20
21
22
2.2 NF
+5V
GND
NC
MIC 1 MUTE C
MIC 1 MUTE T
MIC 2 MUTE C
IR OUTPUT
RELAY CONTROL
D-SUB 37P
AV-452
IR Blaster
R
+5V
10k
1k
+5V
10k
1k
GND
+5V
N
ULN2803AP