Tascam 488 PORTASTUDIO, Руководство пользователя

Страница: 43 / 54

Autolocators Sync Features
39. COUNTER RESET switch: This resets the
COUNTER to 0000 to use any point on the
tape as a starting location. Pressing RTZ
(#40) gets you back to that location.
40. RTZ (Return-To-Zero) key:
When this key is
pressed in any transport mode, the tape will
fast wind to the counter 0000 point
41. REPEAT switch:
This provides a "playback
loop" or "block repeat" between MEMO 1
and MEMO 2 points.
42. LOC 1 key: This key has two functions:
1) If pressed while the MEMO key (#44) is
held down, it loads the current tape location
into MEMO 1 register.
2) If pressed alone, it causes the tape to fast
wind in either direction to the MEMO 1 point
(if this has been memorized).
43.
LOC
2
key:
Similar to LOC 1 ; used to
establish MEMO 2 point and to locate tape
to that memory point
44. MEMO key:
Used together with the LOC 1
and LOC 2 keys to load the current tape
location into memory. See #42 and 43 above.
45. RHSL (Rehearsal) switch:
In rehearsal
mode, any track in REC READY mode is
automatically muted in the monitor when
you press RECORD or the RC-30P footswitch.
However, recording will NOT actually take
place, as long as the RHSL indicator (#38-b)
is blinking. This is designed to help you
rehearse a punch-in without erasing
anything until you're ready to record. Press
the RHSL switch again, except in RECORD, to
turn off RHSL mode before recording.
46. SYNC ON/OFF switch: When this switch is
set to ON, track 8 is electronically
disconnected both from the dbx noise
reduction system and the mixer section of
the 488. Any group mix wont reach track 8
and the TAPE control in channel 8 cant get
any signal from the track. Only sync tones
plugged into the SYNC IN jack can be
recorded on track 8. Similarly, when the 488
is in Play mode, track 8's play signal is sent
directly to the SYNC OUT jack.
If you wish to use Track 8 for standard
recording instead of SYNC tones, turn this
switch OFF.
47. SYNC IN jack: This typically accepts FSK-
converted MIDI sync signals from devices
such as the TASCAM MTS-30. This jack is
active only when the SYNC switch is in its
ON position.
48. SYNC OUT jack:
FSK tones recorded on
track 8 are sent out from this jack to the
MTS-30 or other synchronizers. Active only
when the SYNC switch is in its ON position.
43