Tarts Basic control Скачать руководство пользователя страница 9

© 2014 Tarts Sensors, LLC.  All Rights Reserved.

 

Tarts Basic Control User

’s Guide (12/14)

 

Certifications

 

United States FCC 

 

This equipment has been tested and found to comply with the limits for a Class B digital devices, pursuant to Part 15 of the FCC Rules. 
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment 
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, 
may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a 
particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by 
turning the equipment off and on, the user is encouraged to try to correct the interference by one of more of the following measures: 
 
   • Reorient or relocate the receiving antenna 
   • Increase the separation between the equipment and receiver 
   • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 
   • Consult the dealer or an experienced radio/TV technician for help. 
 

Warning: 

Changes or modifications not expressly approved by Tarts could void  

                 the user’s authority to operate the equipment. 
 

RF Exposure 

 

 

 

 

Tarts Wireless Devices Contain:  

FCC ID: ZTL-RFSC1 
 

This device has been designed to operate with an approved antenna listed below, and having a maximum gain of 5.1 dBi. Antennas 
not included in this list or having a gain greater than 5.1 dBi are strictly prohibited for use with this device. The required antenna 
impedance is 50 ohms. 
 
To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent 
isotropically radiated power (EIRP) is not more than that required for successful communication. 
 

Approved Antennas

 

The following antennas are approved for use with Tarts devices. 

   • Hyperlink HG905RD-RSP (5.1 dBi Rubber Duck) 
   • Pulse W1063 (3.0 dBi Rubber Duck) 
   • ChangHong GSM-09 (2.0 dBi Rubber Duck) 
   • Specialized Manufacturing MC-ANT-20/4.0C (4” whip)

 

 
 
 
 

Содержание Basic control











Отзывы: