6
S A F E T Y
influence of alcohol or drugs.
Keep hands, feet, hair, and clothing away from
equipment while operating. Stay clear of all moving
parts.
Operate only in daylight or satisfactory artificial
light.
Always comply with all state and local lighting and
marking requirements.
Never allow riders on power unit or implement.
Keep seat belt securely fastened.
Falling off power unit can result in death from being
run over or crushed.
Always sit in power unit seat when operating
controls or starting engine. Securely fasten seat
belt, place transmission in neutral, engage brake,
and ensure all other controls are disengaged before
starting power unit engine.
Look down and to the rear and make sure area is
clear before operating in reverse (reverse operation
is not recommended).
Do not operate or transport on steep slopes.
Do not stop, start, or change directions suddenly on
slopes.
Use extreme care and reduce ground speed on
slopes and rough terrain.
Watch for hidden hazards on the terrain during
operation.
Stop power unit and equipment immediately upon
striking an obstruction. Turn off engine, remove key,
inspect, and repair any damage before resuming
operation.
MAINTENANCE
Good maintenance is the owner’s responsibility.
Keep area clean and dry. Be sure electrical outlets
and tools are properly grounded. Use adequate
light for the job at hand.
Make sure there is plenty of ventilation. Never
operate the ATV/UTV in a closed building. Exhaust
fumes may cause asphyxiation.
Before working underneath, carefully read
Operator’s Manual instructions, raise implement,
securely block up all corners with jack stands, and
check stability. Secure blocking prevents equipment
from dropping, or mechanical component failures.
Periodically tighten all bolts, nuts and screws and
check that all pins are properly installed to ensure
unit is in safe condition.
Do not modify, alter, or permit anyone else to
modify or alter the equipment or any of its
components in any way.
Always wear relatively tight and belted clothing to
avoid getting caught in moving parts. Wear sturdy,
rough-soled work shoes and protective equipment
for eyes, hair, hands, ears, and head; wear respirator
or filter mask where appropriate.
Make sure implement is properly secured, adjusted,
and in safe operating condition.
Keep all persons away from operator control
area while performing adjustments, service, or
maintenance.
Never go underneath equipment (lowered to the
ground or raised) unless it is properly blocked
and secured. Never place any part of the body
underneath equipment or between moveable
parts even when the engine has been turned off.
Movement of control levers can cause equipment to
drop or rotate unexpectedly and cause severe injury
or death. Follow Operator’s Manual instructions for
working underneath and blocking procedures.
Make certain all movement of equipment
components has stopped before approaching for
service.
Frequently check blades/tines/shanks. They should
be sharp, free of nicks and cracks, and securely
fastened.
Do not handle blades/tines/shanks with bare hands.
Careless or improper handling may result in serious
injury.
Do not allow debris, grease or oil to build up on
wheels and discs.
STORAGE
Before detaching power unit or performing any
service or maintenance, follow these steps:
disengage power to equipment, lower all raised
components to the ground, set parking brake, stop
engine, remove key, and unfasten seat belt.
Block equipment securely for storage.
Keep children and bystanders away from storage
Содержание ATVCPDC
Страница 17: ...17 ...
