16
Power and activation
Installation
Connection that turns on or off automatically from a remote cable from a CD/DVD player. Use 0.5 mm²
cable.
Note: if the ON/OFF button is pressed, the device will not turn off by remote activation.
The T 0302 was designed to be used in car audio systems with a 12V battery, but it can also be used with an
external 12V plug adapter with a current of at least 2A, which must be purchased separately (in this case,
the consumer should pay attention to the adapter plug that should be standard P4-2mm) . It has an
ON/OFF button that eliminates the REMOTE IN connections.
It can automatically turn on and off by remote activation using the REMOTE IN connection. To do so, keep
the ON/OFF key off (unpressed).
The REMOTE OUT connection can be used for powering amplifiers and is timed to minimize transients
when turning the system on and off.
Output for activating other devices. It can be used to turn on amplifiers or other equipment as long as
they have a remote input. This output is current limited and not suitable for currents greater than 350mA.
Use 0.5 mm² or higher gauge cables.
If the REMOTE IN input is active (remote on) this button will not turn off the device until the REMOTE IN
input is deactivated.
Turns on the sound mixer regardless of the REMOTE IN signal when pressed.
REMOTE IN
REMOTE OUT
POWER ON/OFF
01
02
04
to the battery’s negative terminal
Standard P4 /12V 2mm power connector. Use the TERMINAL/P4 adapter that comes with the product or a
12V adapter source (adapter source doens't come with the product).
Use a 0.75mm² cable for the connections and
use a 1A fuse on the positive wire as close as possible to
the battery
, following the marking on the TERMINAL/P4 adapter:
to the battery's 12V positive terminal.
12V POWER SUPPLY
03
REMOTE
ON
OFF
+
POWER
12V 350mA
OUT
IN
01
02
03
04
Check power polarity and recommended gauge.
it is recommended to install a 1 Ampere fuse on the positive supply terminal.
CAUTION