Taramps SMART CHARGER AUTOCONTROL 120, Инструкция по эксплуатации

Страница: 14 / 16

Battery recharges and amplifier powering
Operation mode:
(***) Use individual power according to the specifications of each power supply (See recommendations
on page 10)
(**) See manufacturer-recommended circuit breaker in the amplifier manual.
(*) Use circuit breaker as indicated in the manual for each power supply.
In this case, in addition to recharging the batteries, the Smart Charger 120A power supply acts as an
auxiliary to the batteries in powering the amplifiers.
The Intelligent Charging System analyzes and monitors battery status and amplifier
power/consumption.
The power supply can be used to recharge various types of 12V battery capacities. For the SMART
CHARGER 120A version, the best performance is obtained for recharging batteries (or battery bank)
between 60Ah and 1800Ah nominal capacity.
The power supply's SMART functions aim to optimize battery recharging by
applying slow charging when needed and automatically switching between
charge, float, and battery equalization modes. In addition, the power supply
constantly monitors its output and identifies when an amplifier is consuming a
high load, thus requiring the maximum power of the power supply ‘’ power supply
Mode``
SMART MODE: The power supply manages all the output voltage and current settings
automatically.
TURN THE POWER SUPPLY ON: The main analysis take place at this stage;
ANALYSIS OF BATTERY CONDITIONS:
-
constant voltage ( V )cycle load.
FIXED VOLTAGE MODE: It is possible to fix the power supply output voltage and disable the
SMART functions. To do this, with the power supply turned off, press the SMART KEY key for 5
seconds. Smart LEDs will display the configuration. After that, every time you press (1S) the
SMART KEY, the mode is changed following this sequence: SMART > 12.6V > 13.8V > 14.4V... To
save the configuration, press and hold the SMART KEY key for 2 seconds
Self analysis of the battery(s). Without battery ,the output voltage will remain fixed at 12.6V.
- constant current ( I ) cycle load.
-
Low Charge →
Cycles: I constant
→
V constant
→
Flut./EQ.
-
Good Charge→
Cycles: V constant
→
Flut./EQ.
BATTERY:
AMPLIFIER
ENGLISH
13