Taramps MD 800.1, Инструкция по эксплуатации

Страница: 11 / 14

Amplifier 2 OHMS Amplifier 1 OHM
2 OHMS 2 OHMS
Resulting
impedance:
1 OHM
4 OHMS 4 OHMS
Resulting
impedance:
2 OHMS
1 - FAN: The MD 800.1, has one internal fan, and cannot be blocked. This fan is controlled by an
intelligent system (Smart Cooler) . The fan only runs at maximum speed after the product
reach a certain temperature level. This function ensures long fan life and silent operation of
your amplifier.
2 - SPEAKER: Output (positive and negative) to loudspeakers connection. Follow the polarity
described and the minimum impedance recommended.
To combine loudspeakers, the resulting impedance must be taken into consideration.
3 - POSITIVE POWER SUPPLY TERMINAL: Use a 10mm² (7 AWG) cable directly from the
positive battery terminal with fuse (50A), as close as possible from the battery.
4 - REMOTE TERMINAL: The remote CD/DVD Player output must be connected by a 0.75mm²
(18 AWG) cable.
5 - NEGATIVE POWER SUPPLY TERMINAL: A 10mm² (7 AWG) cable as short as possible must
be used, connected to the negative battery pole.
It is recommended that all cables must have tinned ends to improve electrical contact .
SHORT-CIRCUIT PROTECTION: Shutdown the amplifier when detect a short-circuit or
impedance lower than the supported at the output.
HIGH VOLTAGE PROTECTION: Shutdown the amplifier if the battery voltage is above 16V.
LOW VOLTAGE PROTECTION: Shutdown the amplifier if the battery voltage is below 9V.
4 3 5
Amplificador 1 Ohm / 2 Ohms
Protection systems
2 1
10
Power supply connectors
ENGLISH