15
Rear Panel
1 - POWER CABLE
: Plugged it into a powered outlet. . This product operates from 127V AC
to220V AC.
2 - SPEAKER OUT:
To connect the loudspeakers. Follow the indicated polarity and the
recommended minimum impedance of 4 ohms for each channel.
3 - OUT:
LINE OUT:
The LINE OUT output allows to send the audio signal (not amplified) to
other equipment, such as another THS 4600, an amplifier or active subwoofer.
The LINE OUT sound is affected by the 3 Band Equalizer and Volume controls. (LOW, MID, HIGH
and VOLUME controllers).
4 - INPUT AUX 1, OPTICAL e AUX 2:
Audio inputs.
Use the frontal key to select.
Using the Optical function, you can count on the AUTO TURN ON system.
With this option enabled, the device is automatically turned on when it recognizes the audio
on the optical input.
It is possible to enable or disable this function. To do this, press and hold the ON / STB key for
5 seconds. The stand by LED will flash 3x for the enabled function and 2x for the disabled
function. (It is enabled by default).
Check the page 18 (Example of use OPTICAL input).
Note:
The OPTICAL input is shared with the AUX 1 input, which means that is not possible to
use both simultaneously. In the case of televisions, audio configuration for
standard
OPTICAL PCM
output may be required, configured in the menu of the TV itself. (Check your
TV manufacturer's manual).
5 - FM ANTENNA:
Indoor wire antenna for FM radio reception. Position the wire antenna in
order to achieve the best FM reception.
1
2
3
4
5
Knowing your equipment
Protection System
When the protections are activated, the STAND BY LED on the front panel turns on
temporarily and the audio output is interrupted. About 2 seconds, or the audio is restored.
The THS 4600 has a protection system against outputs overload and outputs short circuit.
If the protection system or system meets frequently, review the settings and installation of
your system.
