12V
DISJUNTOR
16mm² (5 A
WG)
16mm² (5 A
WG)
Subwoofer /
Woofer 4 ohms
GND
4 ohms
4 ohms
4 ohms
4 ohms
*Illustrative images
Remote Cable 18 AWG
RCA Cable
Taramps
RCA Cable
Taramps
Head Unit
If the head unit doesn't have the
4 RCA outputs, use ‘‘Y’’ type cable
adapters for properly 4 inputs
connection of amplifier.
Connection example in the output: Bridged
Note:
In case of compression drivers and tweeters you must install a passive filter in
the positive terminal of the same ones (Consult transducer’s manufacturer manual).
11
Protection fuse or circuit breaker
_____________________________________________70A
Output cables wire gauge_______________________________
________________13 AWG
Positive / negative power supply cable ___________________
___________________5 AWG
Remote cable ___________________
______________________________________ 18 AWG
Calculated considering a maximum length of 4m. Distance greater than this, you will need to
increase the cable gauges.
Installation
Recommended wire gauge & fuse
CAUTION: All connections to power supply, input and output connectors must
be carried out only with amplifier off.
CAUTION
It is compulsory to install a protection fuses or circuit breakers as close as possible from batteries.
Using wire gauges below the recommendation will result in power loss and
overheating of wiring.
Check polarity and never reverse power supply cables due to the risk of damage to the amplifier.
CAUTION
This equipment is not suitable
for use in places where children may be present.
CAUTION
Examples of connections in the power supply input.
Note: Required battery bank capacity: At least 70Ah
CUIDADO
The entire aluminum surface of
the amplifier serves as a heat
sink. The usually working temperature is 65°C. So, avoid
contact with this surface when the amplifier is in use.
