Taramps DS 800X3, Инструкция по эксплуатации

Страница: 12 / 14

11
Installation
CAUTION: All connections to power supply, input and output connectors must be carried
out only with amplifier off.
Calculated considering a maximum length of 4m. Distance greater than this, you will need to
increase the cable gauges.
Remote cable ___________________ __________________________________________18 AWG
Output cables wire gauge_______________________________ ____________________15 AWG
Caution: Using wire gauges below the recommendation will result in power loss and overheating
of wiring.
It is compulsory to install protection fuses or circuit breakers as close as possible from batteries.
Positive / negative power supply cable ___________________ _______________________ 7 AWG
Check polarity and never reverse power supply cables due to the risk of damage to the amplifier.
Protection fuse or circuit breaker __________________________________________ _______60A
Recommended wire gauge & fuse
12V
CIRCUIT BREAKERS
10mm² (7 A
WG)
10mm² (7 A
WG)
4 ohms
Subwoofer
Woofer
2 ohms
DS800X3 2
DS800X3 1
4 ohms
4 ohms
4 ohms
4 ohms
2 ohms
2 ohms
2 ohms
2 ohms
DS800X3 2
DS800X3 2
DS800X3 1
DS800X3 1
Note: In case of horns and tweeters you must install a passive filter in the positive terminal of the
same ones (Consult transducer’s manufacturer manual).
Note: Required battery bank capacity:
At least 60Ah
*Illustrative images
Remote Cable 18 AWG
RCA Cable
Taramps
Head Unit
Wire Input:
If you choose to use this input, you won’t need
to connect the RCA’S cable and remote signal.
GND
AMPLIFIER - 800WATTS . .