11
Positive / negative power supply cable ___________________
__________________1/0 AWG
Remote cable ___________________
______________________________________ 18 AWG
Protection fuse or circuit breaker
____________________________________________160A
*Calculated considering a maximum length of 4m. Distance greater than this, you will need to
increase the cable gauges.
Output cables wire gauge_______________________________
________________11 AWG
Installation
Recommended wire
*
gauge & fuse
CAUTION: All connections to power supply, input and output connectors must
be carried out only with amplifier off.
CAUTION
Using wire gauges below the recommendation will result in power loss and
overheating of wiring.
It is compulsory to install a protection fuses or circuit breakers as close as possible from batteries.
Check polarity and never reverse power supply cables due to the risk of damage to the amplifier.
CAUTION
12V
Note: Required battery bank capacity:
At least 160Ah
DISJUNTOR
50mm² (1/0 A
WG)
50mm² (1/0 A
WG)
Subwoofer /
Woofer 4 ohms
GND
Remote Cable 0,75mm²
RCA Cable Taramps
RCA Cable Taramps
Note:
In case of compression driver and tweeters you must install a passive filter in the positive
terminal of the same ones (Consult transducer’s manufacturer manual).
Output connection example: Bridged
4 ohms
4 ohms
4 ohms
4 ohms
Head Unit
If the head unit doesn't have the 4 RCA outputs,
use ‘‘Y’’ type cable adapters for properly 4 inputs
connection of amplifier.
*Illustrative images
This equipment is not suitable
for use in places where children may be present.
CAUTION
The entire aluminum surface of
the amplifier serves as a heat sink.
Therefore, avoid contact with this
surface when the amplifier is in
use.
CAUTION
Saída RCA
ou
saída a FIO
