8
3.
Hold the half shafts next to each other and mark them so each end is approximately ½” from hitting the end of
the telescopic profiles.
4.
Shorten the inner and out guard tubes equally.
5.
Shorten the inner and outer profiles by the same length as the guard tubes. Using a rattail file, round off all
sharp edges and burrs. Grease the telescopic profile generously before reassembling.
Be sure each end of the driveline is connected securely with the locking pin on the tractor end and two roll
pins on the implement end. Connect the driveline shielding chains to the tractor and to the implement to prevent
the protective shielding from rotating during operation. If it was necessary to remove the PTO shielding to do
any of the above operations, do not forget to replace it..
CAUTION: Load hopper with product only after the spreader has been correctly attached to the tractor.
WARNING: Chemicals may cause eye, skin or breathing problems. Always wear a face mask, gloves, and
goggles when filling hopper. Refer to chemical manufacturer’s label for specific safety information.
Operation
Before starting to use, never forget that the
operator is responsible
for the following:
1.
Safe and correct driving of the tractor and spreader.
2.
To learn precise, safe operating procedures for both the tractor and the spreader.
3.
To ensure all maintenance and lubrication has been performed on the spreader.
4.
To have read and understood all safety aspects for the spreader in the Operator’s
Manual.
5.
To have read and understood all safety decals on the spreader.
6.
Checking the tractor tires for the proper pressure in accordance with the tractor
Operator’s Manual.
7.
Checking that all shields are on the machine and securely in place.
8.
Making sure the proper attire is worn. Avoiding loose fitting clothing which can become entangled. Wearing
sturdy, tough-soled work shoes and protective equipment for eyes, hands, ears, and head. Never operate
tractor or implements in bare feet, sandals, or sneakers.
9.
Ensuring proper lighting is available, sunlight or good artificial lighting.
Prior to start working do the following:
1.
Make sure there are no obstructions.
2.
Run machine under a no-load condition for a short while to assure that everything is functioning properly.
3.
Adjust all settings for the desired quantity distribution and spread pattern.
4.
Shift the transmission to a slow speed gear and start forward, increase the ground speed by shifting up- ward
until the desired speed is obtained. Do not use in reverse unless absolutely necessary and only after careful
observation of the area behind the spreader.
Operating Techniques
The material delivery is controlled by t h e lever that opens the orifices in the hopper bottom. The lever
has up to twenty-seven positions that it can be locked into depending on the desired output. To ensure a constant
output of product always keep the following factors into account.
The quantity of material distributed per acre depends on the following factors:
1.
Tractor ground speed.
2.
Unit weight and size of the material to be spread.
3.
Spreading width.
4.
Position of the lever connected to the hopper gates.
Содержание RONDINI SQFT
