8
……................
by
TAPMATIC
⚫
802 Clearwater Loop, Post Falls ID 83854
Tel. 800 854
-
6019
⚫
Tel. 001 208 773
-
2951
⚫
Fax 001 208 773
-
3021
⚫
www.tapmatic.com
Adjusting the Force:
The spring force for both compression and extension can be adjusted simultaneously and equal-
ly by turning the sleeve. There is a scale for reference with setting 0 being the lightest force and
setting 6 the highest.
Floating over surfaces with height variation:
When floating over edges that vary in height , using
lower force settings will result in the most consistent
edge break.
Setting 0
Setting 6
Factors that influence the size of the edge break:
•
Increasing the force setting will increase the edge break
•
Increasing the compression or extension distance into the work piece will increase the
edge break.
•
Reducing the feed rate will increase the size of the edge break.
Factors that influence the finish:
•
Higher Spindle Speed improves the finish.
•
Slower feed rates will improve the finish.
•
Taking a second pass around the part can also improve the finish.
•
The tooth pattern of the cutting tool can also influence the finish. A finer tooth pattern
can improve the finish but some materials like aluminum may cause the cutting tool to
load up with material if the tooth pattern is too fine.
•
Using coolant lubrication will improve the finish and cutting tool life.
Safety and Operation Instructions for
DeBurr
-
Z
+
