TapFlo SPT Series, Оригинальная инструкция

Страница: 16 / 32

3. Installation
IOM manual – SPT series 16
Before connecting the cable to the terminal board, make sure that the power supply (i.e. circuit
breaker) is properly disconnected. Failure to do so may lead to electrical shock, short, or injury
caused by the unintended pump start.
CAUTION:
➢
If the cable must be extended, use an extension cable with the same or larger core size
as that of the cable that is provided with the pump. Using a cable of proper size will
prevent the motor from attaining its full capabilities or may cause the cable to overheat,
which may lead to fire, current leakage, or electrical shock.
➢
If a cable with a cut or damaged sheath is submerged in water, the water may enter
the pump and cause the motor to short. This will damage the pump, which may lead
to current leakage, or electrical shock, or burn-out.
➢
To prevent the cable from cuts or twists, which will damage the pump and may lead to
current leakage, electrical shock, or fire, make sure that the tires of vehicles do not run
over the cable.
➢
If the cable must be submerged in water, make sure to use extension method providing
proper IP (Ingres Protection) rating. Failure to do so may lead to current leakage,
electrical shock, or burn-out.
Never submerge cable end in water. If the cable must be extended, use an
extension cable with the same or larger core
size as that of the cable that is provided with
the pump.
To prevent water from leaking inside the
cable, make sure to securely maid the cable
connection part. To avoid cable damage, route the cable so
that the cable is not bent, kinked, or pressed
against anything.