S n a p S t a n d
M X S e r i e s
™
10
Setup for Adjustable MAX Cut-Off
3.
Secure the tape measures in place
by “punching" down the edge of the
pivot arm onto the tape measure. Use a
standard nail set or punch.
IMPORTANT! Read this safety information before using product.
1.
Always keep hands and fi ngers clear of the knives during all phases of use.
2.
If using both hands to push tool through material, ensure hands are not in the path of
the exiting material as it leaves the rear area of the tool.
3.
Remove cut-off from anvil prior to bending material. Failure to do so can cause the
tool to fall from brake resulting in tool damage or personal injury to user.
4.
Never use tool to cut material not fi rmly clamped in brake.
LIST OF PARTS:
(1) Adjustable MAX Cut-Off
(2) MX Material Stop Kit #14485
1.
Slide measuring tapes into Pivot Arm
slots from rear of Pivot Arm till they
stop. Tape measures take into account
1 1/2" difference between the bending
edge and the shear point of Cut-Off for
accurate cuts.
2.
Slide material stop onto Pivot Arms
from rear as shown.
Note: Recommended locations are on
the second castings in from each end
of your brake.
Tools Needed for Initial Set Up:
hammer, punch or nail set,
9/16" wrench, Phillips screw driver.
