Part No. 0015052 Rev. A 02/05
©2005 LOUD Technologies Inc. All Rights Reserved.
It is important to keep your receipt in a safe place, and not a bad idea to write your product information
here for future reference (i.e., insurance claims, tech support, return authorization, etc.).
PRODUCT SERIAL #:
PURCHASED AT:
DATE OF PURCHASE:
DB-1P
INPUT
THRU
INST
AMP
FLAT
FILTER
1
2
3
4
1. INPUT
— Connect the signal source to this 1/4" unbalanced TS jack.
2. INST/AMP
— Leave this switch out when connecting an instrument
or line-level signal to the INPUT jack. Push this switch in when
connecting a speaker-level signal (for example, from a guitar
amplifier’s speaker output).
3. FLAT/FILTER
— Push this switch in to engage a high-cut filter to
reduce hiss and noise when using the AMP input setting. The filter
has no effect when the input is set to INST (2).
4. THRU
— This 1/4" unbalanced TS jack is in parallel with the INPUT
jack and provides a “Thru” connection of the input signal for
sending to an amplifier onstage.
5. OUTPUT
— This balanced XLR jack provides a low-impedance mic-
level signal for connecting to a microphone input on a mixer.
Pin 1 = Ground
Pin 2 = Hot (+) and in-phase with the input signal
Pin 3 = Cold (–)
6. GND/LIFT
— This switch makes or breaks the input ground to pin 1
of the XLR output jack. When the switch is in the OUT position, the
ground is connected, and when the switch is pushed IN, the ground
is disconnected (LIFTED).
OUTPUT
GND
LIFT
5
6
2
