FAST-18T Radar Speed Display Trailer user Manual
9
`Holding the button will scroll through the numbers faster for quicker setup. If the desired setting is
passed, the numbers will start over after 99.
If using the optional key chain remote, the bottom left button advances the numbers while the bottom
right button reverses them.
To start over, either turn off/on the sign with the power key OR when using the key chain remote, hold the
bottom left button in for 3 seconds to reset the sign.
After setting the clock, (see
“Setting the Clock and Timed Events”
) the sign will revert back to Normal Mode
(NM). If Violator Alert mode is desired, it will have to be set to“VA” mode again.
VIOLATOR ALERT SETTINGS SUMMARY
1. Push button until display shows “VA”
2. Wait five seconds for MS (Minimum Speed) to display.
Push the button to set the desired speed.
3. Wait five seconds for SL (SLOW) to display.
Push the button to set desired speed.
4. Wait five seconds for RB (Flashing Red & Blue) to display.
Push the button to set desired speed.
5. Wait five seconds for LF (Flashing Strobe) to display.
Push the button to set desired speed.
6. Wait five seconds for FL (Flashing Speed) to display.
Push the button to set desired speed.
7. Wait five seconds for BL (Blanking Speed) to display.
Push the button to set desired speed.
8. After five seconds the last speed sets and the display goes dark
TRAFFIC SET-UP EXAMPLES
35 MPH NEIGHBORHOOD SPEED LIMIT
Set the “MS” (the radar detected Minimum Speed limit) at 5 mph, the “SLOW DOWN” message at 35, “Flashing
Speed” at 40mph, the “Red and Blues” at 50 and the Blanking Speed at 60. This is what will happen: Oncoming
vehicles speeds will be shown on the sign traveling from 5 to 34 MPH. If the vehicle is traveling 35 to 39, the
SLOW DOWN message will flash. Between 41 and 49, their speed will be displayed while flashing. Over 50MPH,
the display will show the Red + Blue flashing lights pattern. At 60 and above, the display is blank. As the
vehicle slows, the appropriate “Violator Alert” will show for their speed until they reach 34 MPH where their
speed is displayed normally.
SCHOOL ZONES
Set the “MS” (the radar detected Minimum Speed limit) at 15 mph (so drivers in a school zone obeying the
speed limit are not distracted), the “Flashing Speed” at 16mph and the “Blanking Speed” for 40mph. This is
what will happen: For speeds under 15 MPH, no speed will be displayed. The display will flash the speed for
vehicles traveling between 16 and 39 MPH. No speed will be displayed above 40 MPH.
