FAST-18 Pole-Mount Radar Speed Display Sign user Manual
7
VIOLATOR ALERT 4: FL - FLASHING SPEED
The display will now show “FL”. When drivers go over this setting, they will
see their over-the-limit speed flash. The operator has 5 seconds to start
pushing the button in-order to change the speed setting. Press the button
until the desired speed setting is reached. Once reached, stop and wait for
the next screen to appear after approximately 5 seconds.
VIOLATOR ALERT 5: BL - BLANKING SPEED
The display will show “BL” which is the speed limit that the display will
no longer show the oncoming vehicles speed. This setting will prevent
drivers from increasing their speed over this speed limit to see how they
can go. Press the button until the desired speed setting is reached. Wait
approximately 5 seconds and the sign will go dark. The display is now in
service and operating in “Violator Alerts” mode.
NOTES:
After this last “BL” screen, all of the violator alert settings have been saved even after the sign is switched
off. When the sign is turned on again, it will run through all of the modes and their speed settings for the
operator to review.
If changes are needed, press the sign mounted button for 5 seconds which will start the mode settings to
display again. If using the key chain remote, hold the left button in for 1 second for the same effect.
If desired, the sign can be pre-set at your base facility for transportation and set-up at a different location.
The violator alerts can be set in any order, but not at the same speed. If attempted,this setting will skip to
the next available number. To get the best effect from the alerts, set the speeds at least 3-4 MPH difference.
If you wish to not use one of the violator alert settings, set the speed higher than the blanking speed
threshold.
Holding the button will scroll through the numbers er for quicker setup. If the desired setting is passed,
the numbers will start over after 99.
If using the optional key chain remote, the bottom left button advances the numbers while the bottom
right button reverses them.
To start over, either turn off/on the sign with the power key OR when using the key chain remote, hold the
bottom left button in for 3 seconds.
After setting the clock, (see
“Setting the Clock and Timed Events”
) the sign will revert back to Normal Mode
(NM). If Violator Alert mode is desired, it will have to be set to“VA” mode again.
“Flashing Speed”
“Blanking Speed”