9
TapcoTools.com
800.521.8486
Replacing the Vinyl Strip
Remove Vinyl Strip
Grasp other end of strip with pliers and
pull Strip out of slot. Check slot for burrs,
metal chips, dirt, etc. and clean if neces-
sary.
Drill Out “Center Punch”
Marks
Clean out slots that hold Vinyl Strip
at both ends of Brake using #26 drill
bit.
Tools needed: drill, #26 drill bit, hammer, slotted screw driver, light oil, pliers or vice grips, center punch, and safety glasses
2
3
4
Replace Vinyl Strip
Replace Vinyl Strip by lightly lubricating
leading end with small amount of oil
while sliding into slot. Wipe off excess oil
afterwards.
5
Punch Vinyl
When Vinyl Strip is in place “cen-
ter punch” both ends to prevent
slippage.
6
Close Brake
Move Locking Handle to left.
1
REPLACING THE STAINLESS BENDING EDGE
Loosen Stainless Edge
To loosen old Stainless Bending Edge, insert
screwdriver behind one end as indicated and
twist to release from end.
Remove Stainless Edge
Grasp one end of Stainless Bending Edge
with pliers or vise grips and pull away with
a twisting motion. Note: Stainless Bend-
ing Edge is not reusable after removal.
Install New Stainless Edge
Starting on end away from Locking Handle
align new Stainless Edge flush with end of
Clamping Bar and tap into place sideways
with Rubber Mallet.
After replacement, “Center Punch” Stain-
less Bending Edge on ends to prevent
possible sliding.
Open Brake
Move Locking Handle to the right.
Tools needed:
slotted screwdriver, rubber mallet, vice grip or pliers, center punch, hammer, and safety glasses
1
2
3
4
5
Loosen Vinyl Strip
Push Vinyl Strip from one end by tapping on
the edge of upright screwdriver as indicated.
Make sure opposite end of slot is free of dirt
and obstruction. CAUTION: Avoid hitting
hinge with hammer.
