TROUBLESHOOTING GUIDE
1. If the information listed in the troubleshooting guide can’t solve your problem, please
email us for help.
2. Failure to keep this unit clean from mineral deposits may affect operation of this unit.
3. Customer failure to follow these instructions may void the warranty.
1
3
2
1. Spring
2. Water Floater
3. Sealing Ring
Problem
Possible Cause
Solution
Power adapter not plugged in
No power from power outlet
Power adapter not connect
to the input port
Ensure the power adapter is
properly plugged in
Try another power outlet
Connect power adapter to
the input port.
LED indicator is off
Ensure the floater is
secured properly to the tank
bottom allowing water to pass
through to the base
2
Adjust the water floater to
a horizontal position and
make sure it can rise up with
water
2
Water floater stuck
2
No water in the water
reservoir
LED indicator stays red
Not enough water inside the
tank
Refill and reinstall the water tank
The LED Indicator will light up,
but no mist or little mist is
produced
Mist level is set too low
Adjust to maximum mist
Mineral buildup on the
atomize
Feel if any air comes out from
the nozzle. If yes, then clean
water scale on the atomizer
with s soft cloth as instructed
The base might be overfilled
Remove the tank, empty the
base and place the filled tank
on the empty base
Tank leakage
Tank may be damaged
Check for possible cracks in
the tank, replace if necessary
Tank cap is not tightened
securely
Tighten the tank cap
Spring stuck
Ensure the spring is
properly secured to the tank
bottom allowing water to
pass through to the base.
1
1
Sealing ring was not
installed on tank cap
Install the sealing ring on
the tank cap, please contact
us if it is missing
3
3
Mist level is set too high for
the room size
1. Check if the room is too
humid and adjust to lower
mist. 40%-60% works best
2. Open door and windows,
or change to a larger room
Air inlet is blocked
Humidifier should be placed
on a hard flat surface, 2 feet
above the floor, 12 inches
away from the wall. Point
nozzle away from wall or
window
Low indoor temperature
leads to liquefaction
Raise the room temperature
to 25°C / 77°F
Mist height is low, damping
surrounding desk or floor.
Condensation forms around
humidifier or on windows
and walls
16
15
Содержание TT-AH038
Страница 1: ...150 200mm 128 80 Model TT AH038...
