Tannoy Ellipse 10 iDP, Руководство пользователя

Страница: 18 / 56

5.1 Analog Set-up
The diagram shows how to connect a 5.1 analog set-up.
} The Centre monitor is set as the System Controller by leaving
out the TC Link button on the rear panel.
} The Centre monitor receives audio for both centre (input 1) &
LFE channels (input 2) via the analog input connectors. The LFE
subwoofer is fed via the RJ-45 connection from the left monitor.
} RJ45 Network connections from the Centre monitor to the Left &
Right monitors are required.
} The Left Monitor receives audio for both Left (input 1) & LS
channels (input 2) via the analog input connectors. The LS monitor
is fed via the RJ-45 connection from the Left monitor.
} The Right Monitor receives audio for both Right (input 1) & RS
channels (input 2) via the analog input connectors. The RS monitor
is fed via the RJ-45 connection from the Right monitor.
} When no Bass management is selected, only the LFE signal will be
sent to the subwoofer.
} When Bass management is selected, low frequency content from
the 5 main channels is extracted and sent to the subwoofer where
it is summed with the LFE channel
} The iDP ™ Remote, iDP SOFT ™ or PC-iP ™ can be connected to any spare
TC Link “out” connection.
} ! REMEMBER – To set a master monitor as the system controller
the TC Link button on the rear panel MUST be in the out position.
5.1 Digital Set-up
The diagram shows how to connect a 5.1 digital set-up.
All Master monitors require installed digital I/O cards.
AES signal is fed to input 2 of these cards.
} The Centre monitor is set as the System Controller by leaving out
the TC Link button on the rear panel.
} The Centre monitor receives audio for both centre & LFE channels
via the AES input connector (input 2). The LFE subwoofer is fed via
the RJ-45 connection from the left monitor.
} RJ45 Network connections from the Centre monitor to the Left &
Right monitors are required.
} The Left Monitor receives audio for both Left & LS channels via the
AES input connector (input 2). The LS monitor is fed via the RJ-45
connection from the Left monitor.
} The Right Monitor receives audio for both Right & RS channels via
the AES input connector (input 2). The RS monitor is fed via the
RJ-45 connection from the Left monitor.
} When no Bass management is selected, only the LFE signal will be
sent to the subwoofer.
} When Bass management is selected, low frequency content from
the 5 main channels is extracted and sent to the subwoofer where
it is summed with the LFE channel
} The iDP ™ Remote, iDP SOFT ™ or PC-iP ™ can be connected to any spare
TC Link “out” connection.
} ! REMEMBER – To set a master monitor as the system controller the
TC Link button on the rear panel MUST be in the out position.
18