Tannoy Eclipse, Руководство пользователя

Страница: 3 / 12

ECLIPSE MANUAL_03
INTRODUCTION
Thank you for selecting Eclipse loudspeakers developed in the UK by our dedicated team of design engineers. They are
the choice of discriminating music lovers the world over. Musical excellence is designed into our loudspeakers from the
start. Careful selection of the very best components combined with strict quality control procedures in the production
process ensures this level of excellence is maintained.
To gain maximum performance from your loudspeakers, please take time to read this owner’s manual in full
before installation.
Loudspeakers are electromechanical devices that ‘run-in’ through use; performance will therefore improve after an
initial period of 24hrs use. Once they have been further run-in over a longer period, there will be clear enhancement of
the stereo imaging, mid-band quality and bass performance characteristics.
We are confident that you will continue to enjoy your new Eclipse loudspeakers for many years to come.
AMPLIFIER CHOICE
Consult the product specification as this clearly shows the acceptable power range for amplifier matching to your
speakers. The high peak power handling of Eclipse loudspeakers permits responsible use with more powerful amplifiers
- please read the Warranty.
As with all loudspeaker systems, the power handling is a function of voice coil thermal capacity. Care should be taken
to avoid overdriving any amplifier, as this will cause output overload resulting in ‘clipping’ or distortion within the output
signal. This, if done for any extended period, will cause damage to the speakers.
Generally an amplifier of higher power that is running hard, but free of distortion, will do less damage to the loudspeaker
than a lower power amplifier continually clipping. Remember also that a high powered amplifier running at less than
90% of output power generally sounds a great deal better than a lower powered example struggling to achieve 100%.
An amplifier with insufficient drive capability will not allow the full performance of the loudspeakers to be realised.
CABLE CHOICE
Always use the best quality of cable available within your budget. High quality audio signals passing from the
amplifier to the loudspeaker are unusual in their demands on the cable. Wide dynamic range and frequency bandwidth
information has to coexist with the ability to transmit peak currents of at least 10 amps, without incurring any loss
or signal impairment. This explains why the sound quality of the information reproduced by the loudspeakers is so
dependent on the physical properties of the cables connecting them to the amplifier.
We would recommend that you always keep the cable runs as short as possible and the same length for each speaker.
Remember that cable construction can affect the sound quality so be prepared to experiment to find a cable that suits
your ear and audio system.
UNPACKING
To unpack the loudspeakers from their boxes remove tape from the top then fold the flaps right back before inverting
the carton and contents. Lift the carton clear of the contents then remove all inner packaging.
It is strongly recommended that you store all the packaging to allow protected transportation in future.