W W W . T A N N E N - P A R A D I E S . D E
- 6 -
2)
Put the spacing rod with the adjusting lever to the right and from up on the
extension rod, and make adjustments in line with the size of the tree to be tapped.
If the user is left-handed, the hand knob on the spacing rod can be turned by 180°,
so that the machine can be operated on the left side.
3)
Before using the machine, check regularly if the drill is in place and not damaged.
4)
If you use the machine on unpaved surfaces, make sure that the motor is at a safe
distance of at least 8 cm from the ground. If you drill more than 50 trees in one
place, remove chips collected under the machine or shift it to another place. Chips
can clog up the air gap through which air reaches the drilling machine, which can
cause overheating.
5)
The end of the tree trunk: the end of the trunk should be cut with a saw at right
angles (+/- 20°) to the axis of the tree (if necessary, make appropriate
improvements).
Start and drilling
1) Before setting, please check whether the cone clamp is free.
2) Start the machine on the green-red keyboard.
3) Insert the end of the tree trunk into the drill chuck.
4) Set the upper centering rod set in such a way that about 2/3 of the tree length lies
in the chuck.
5) When drilling, hold the tree with the upper hand on the trunk at the spacing rod
and fix the lower 1/3 tree length with the lower hand.
