Tanita AM-180E, Руководство пользователя

Страница: 5 / 20

P.9 P.8
9 8
① Loosen the battery cover
screw with the screwdriver
(provided).
The battery has little power left. Replace soon with a new
battery (CR2032).
The battery has run out of power and measurement is no
longer possible. Replace with a new battery (CR2032).
② Remove the battery cover.
③ Insert the battery (CR2032) with
its side facing up.
◯
Blinking
Lo indication
About the
【
Battery Mark
】
④ Insert the battery cover
in the direction marked
by the arrow.
⑤ Tighten the battery cover
screw firmly.
Next, perform the initial setup.
⇒
p.10
The battery can be removed easily by prizing the
part shown in the figure with a fine-tipped object.
※ For details on opening and closing the battery
cover and inserting the battery, see page 8.
◆
Keep batteries out of the reach of babies and small
children.
WARNING
PROHIBITED
Replacing the Battery Inserting the Battery
◆
Do not replace the battery between 23:55 pm and 00:05 am. Doing
so may interfere with the data.
◆ Measured values are applied and recorded to memory once every hour on the hour (e.g.
15:00). When the battery is replaced, the measurement data before measured values are
applied is cleared, and measurement is resumed from the applied measured values.
◆ Replace the battery before using in the morning, for example.
◆ Note that past memory may be damaged if the wrong current year,
date and time are set when the battery is replaced.
Before Replacing the Battery
Return the inner ring to its
original position if it comes loose.
◆ After replacing the battery, perform the initial setup again. See page 10.
※ The battery provided is a test battery, and so may have a short service life.
※ The life of a new battery when used for 16 hours per day is about six months.
AM-180E
Before Using
＋