Tangent NET-200, Инструкция по эксплуатации

Страница: 19 / 36

19
It is possible, and in some locations highly likely, that your radio will find more than one wireless access point,
in which case you can choose which one you want to connect to. Turn the
CONTROL/TUNING knob on the
radio to see the ESSID for each access point the radio has found.
Step 3 - Connect to the wireless network
When the ESSID for the access point you want to connect to is displayed on the screen, press the
CONTROL/TUNING
button.
If your network is not configured to need an encryption code, the screen should say:
Connecting to
network
Then:
Network OK
If the screen displays either:
Enter WEP key
Or:
Enter WPA key
Then the network is using one of the encryption systems: Wired Equivalent Privacy (WEP) or Wi-Fi Protected
Access (WPA). You therefore need to enter the correct WEP or WPA code into the radio to get it to
communicate with your network.
Only the person who set up the network in the first place knows this code; if that person is not you then you
need to find out what it is.
After 3 seconds, the display goes into the code entry mode. To enter the code, use the
CONTROL/TUNING
knob to select each character of the code in turn, pressing the
CONTROL/TUNING
button after each
character. Note that WEP and WPA codes are sensitive to upper and lower case characters so you must enter
them exactly.
After the final character, use the
CONTROL/TUNING knob to select the END character and press the
CONTROL/TUNING button.
The radio should now be able to connect to the network.
Steps for connecting your radio to your wired network
For connection via a wired network, simply plug in the Ethernet cable from your switch or hub before you
connect the radio to power. The radio will always prioritize a wired network in front of a wireless network if it is
available.
The RJ-45 connecter has two LEDs near the port that shows the status of the connection. The Green LED
indicates if a live connection is present. The yellow LED indicates if there are any on going traffic on the wired
connection
.
If you wish to make sure the radio only will attempt to connect to either a wired or a wireless network, you can
lock it to use only a wired or wireless connection.
1. Press the
CONTROL/TUNING
button to return to the top-level menu.
( Note : if you make a mistake at any point, press the BACK button to go back to the previous screen.)