Tangent Scale Models
PS-2CD 4000 Kit Assembly Instructions
7
6.
Attach coupler bolster pieces:
Degate and clean up the coupler end bolster
pieces from the
Underframe parts sprue (see photo below). After making sure to test fit the parts first, mount
the A end part on the A end; the A end part has NO small holes in it for mounting the brake
appliances. Then, mount the B end part in place. For each of these, the flat bolster sheet needs
to mount flush with the bottom of the sidesill of the body mold. The entire piece should be
parallel to the carbody, with the angled end butting up against the slope of the bay. Cement as
appropriate. The corners of the part should meet up with the bottom of the body sell corner
posts. As the part dries,
make sure it remains parallel to the carbody.
This is important, so
the end frames (attached later), fit correctly.
