T&S B-3950 Series, Инструкция по установке и обслуживанию

Страница: 10 / 12

General Instructions
Installation
Figure 1 shows an explosion of the waste drain installation
10
Sink Bowl Snap-in Strainer
Sink Flange
Gasket
Waste Drain
Assembly
Figure 1
1. Remove the Snap-in Strainer and unscrew the Sink Flange from the Waste Drain
Assembly. Apply a bead of Plumber’s Putty to the bottom of the Sink Flange where it
contacts the sink bowl.
2. Make sure the underside and inside mating surfaces of the sink bowl in the area of
the drain are clean.
3. Install the Waste Drain Assembly and Gasket from below the sink.
4. Install the Sink Flange thru the sink drain opening and screw it into the Waste Drain
Assembly below.
5. Before tightening, position the waste drain Handle to the desired location. Tighten
the Sink Flange securely with a Sink Flange Tool* or similar.
Sink Flange Tool
Figure 2
* Sink Flange Installation Tool
# 017670-45
is available through T&S (see last page).
*