T&C TC30, Руководство по установке

Страница: 5 / 16

5
TC30.NG06C 200411-16
Ember Material Placement
LOG
GRATE
GLOWING EMBERS
Ember Material
A large bag of ember material is shipped
with the fi replace and needs to be
installed on the burner to ensure optimum
performance and fl ame appearance.
1. Pull apart the material into ember size
pieces (approximately 1” square) and
gently place them into the burner pan.
Do not compress, leave them loose for
best performance.
2. Fill the burner pan level with the top of
the pan at rear, and gradually sloping
forward down to the fi rebox fl oor at the
front, covering both burner tubes.
3. Place remaining ember material outside
of the burner pan as desired to cover-up
gas lines and brackets.
Note: Ember material placement and
amount will affect fl ame appear-
ance. More ember material results
in lower flame height. Add or
remove as needed until desired
fl ame affect.
Fig. # 6
Gas plumbing and vent connections should
be completed before proceeding.
The logs are are fragile and should be
handled with care. Unpack and inspect
log set. There should be a total of 7 logs.
Position the logs as indicated by the following
pictures. Place the rear log back against the
tabs located at the back of the grate. Place
left log as pictured, engaging the pins with
corresponding holes on the underside of
the log. Install the right log into the grate
and pull it forward into position as shown.
Place the four remaining small logs on the
fl oor of the fi rebox in the positions and order
as shown.
Log Set Assembly
Fig. # 7
LOG #1