T&C TC30, Инструкции по установке

Страница: 8 / 16

If the unit is to be used on propane
convert as follows using the
components supplied with this
burner:
CAUTION
The gas supply and electrical power
shall be shut off before proceeding
with the conversion.
Note: Factory supplied components must be
used to ensure correct input.
After conversion confirm proper manifold
pressure.
1. Ensure the burner, pilot and gas
supply are turned off, and the
appliance has cooled.
2. Remove the two screws securing the
the burner grate.
(Fig. #19)
3. Remove the two screws securing the
manifold assembly to the burner.
(Fig. #20)
4. Remove the manifold assembly from the
burner. (Fig. #21)
5. With a ½” wrench remove the natural gas
orifice (#32) and replace with propane
orifice (#48)(our part # 5021.3407)
(Fig. #22)
WARNING
This conversion kit
shall be installed by a
qualified service agency
in accordance with the
manufacturer's instructions
and all applicable codes
and requirements of
the authority having
jurisdiction.
If the information in these
instructions is not followed
exactly, a fire, explosion
or production of carbon
monoxide may result
causing property damage,
personal injury or loss of
life.
The qualified service
agency is responsible for
the proper installation of
this kit.
The installation is not
proper and complete
until the operation of the
converted appliance is
checked as specified in the
manufacturer's instructions
supplied with the kit.
Fig #19
Fig #20
Fig #21
Fig #22
8
TC30.NG01.C 140708
Propane Conversion