D14489.01—JULY 2009
9
Quick Set C20/C20plus
Administrator Guide
Contents
Introduction
Getting started
About the menus
Advanced settings
Settings Library
Cameras
Appendices
Contact us
Getting started
!
Assemble your system
The illustration shows you the basic setup when connecting the
monitor, PC, camera, microphone, loudspeakers (if applicable), LAN
and line voltage to the TANDBERG Codec C20.
CAUTION!
In order to be able to use the system for video calls, all
orange colored sockets must be connected.
Power switch
The power switch (push button) is located on the rear side.
s
Push the button to boot up the codec.
s
Push and
hold
the button for
1 second
to shut down the codec.
s
Push and
hold
the button for
7 seconds
to force a shut down of
the codec.
The LED in front of the codec
The LED in front of the codec indicates the status of the codec.
s
When the LED is
OFF
the codec is Off.
s
The LED
flashes
green
during the boot up and shut down of the
codec.
s
The LED
pulses
green
when the infrared (IR) port is activated. This
will occur when the remote control is in use.
s
The LED is
steady
green
when the codec is On, in Standby mode
or in Presentation mode.
s
When the LED is
red
this indicates an Error has occurred.
The codec must be switched off and disconnected from the
line voltage whenever connecting or disconnecting other
equipment.
HDMI
HDMI
