D14489.01—JULY 2009
44
Quick Set C20/C20plus
Administrator Guide
Contents
Introduction
Getting started
About the menus
Advanced settings
Settings Library
Cameras
Appendices
Contact us
Appendices
Video system
The distance between the table and the video system
s
Consult the user documentation for the monitor to find the
distance to the table to allow all participants to see a clear picture
on screen.
The camera
The Quick Set C20 is shipped with TANDBERG PrecisionHD 1080p 4x
zoom or TANDBERG PrecisionHD 1080p 12x zoom.
s
Make sure all participants are covered within the camera angle.
The maximum zoom out for TANDBERG PrecisionHD 1080p
camera is 72°.
s
Adjust the camera view (using zoom in/out) to allow the
participants to be shown in full size on screen, and to keep eye
contact with each other at the same eye level
s
The camera should capture all participants in the room
s
If the participants are sitting too close to the monitor the camera
will “look down” at the participants. This may not give a good
presentation of the participants at the far end.
The microphone
The Quick Set C20 is shipped with one microphone. Optional, you can
connect two microphones. See the General room guidelines section
for how to position the microphones.
s
Place the microphone nearby the meeting participants.
s
The microphone must not be hidden behind obstacles like laptop,
projector or other equipment placed on the table.
s
Place the microphone away from noisy equipment like computer
and projector fans, power outlets or similar arrangements on the
table. The microphone will pick up noise from these arrangements
quite strongly.
s
Avoid unnecessary noise like paper rustling and tapping with
fingers on the table.
Remote
control
Camera view
- with max zoom
out
Adjust the camera view
Press the Zoom +/– button on the
remote control to adjust the picture
on screen.
Adjust the camera view to allow the
participants to have eye contact with
each other at the same eye level.
Microphone
