2
Mechanical Installation
For mechanical mounting specifications, please refer to Figure 1.
Allowed mounting position is either horizontal with the indicator LEDs to the
right, or vertical with the LEDs up.
The drive occupies a half-size 5.25-inch slot with standard holes for mounting
screws on both sides of the drive chassis and at the bottom of the drive.
Figure 1
Mounting specifications
Important!
Mounting screw
requirements
•
Only M3 (metric) screws must be used for mounting the drive
•
Maximum permitted screw penetration:
3.0 mm
•
Minimum required screw penetration:
2.0 mm
•
Screw torque, mounting screws:
0.5 Nm
•
Screws are supplied with all the Tandberg 420LTO drive
variants
Do not use longer screws or higher screw torque
than specified!
Figure 2
Allowed mounting orientations
