D 14127.01
01.2008
12
Table of
Contents
Trademarks &
Copyright
Patents &
Disclaimers
Safety/
Environmental
To Get You
Up and Going
About
Administrator
Settings
General
Settings
Audio
Settings
Security
Settings
Network
Settings
Profiles &
Wizard
Diagnostics
Reset &
Upgrade
To Get You
Up and Going
TANDBERG 150
MXP
ADMINISTRATOR’S GUIDE
Unpacking and Installation
Assembling the unit is really easy. The system lies fully as-
sembled in the box. Remove the accessories box and carefully
lift the system out of the box. To protect the camera lens while
installing, we recommend that you let the camera lens cap
remain on. In the accessories box you should find:
LAN cable
•
Power adapter and power cable
•
Please report any discrepancies to your TANDBERG Representa-
tive immediately.
Handset
is an optional device that must be ordered separately.
Contact your TANDBERG representative for more information.
How to configure the unit is
described in Administrator
Settings.
Assembling the Unit
Mounting the (optional) Handset
Slide the handset brack-
et into the system’s
bottom plate tracks.
Place the system in an
upright position and lay
the handset in its place.
The handset is held in
place by magnets.
Connecting Cables
Socket for optional handset’s cable.
See lower left corner of this page for
details.
Socket for optional headset.
The TAND-
BERG 150
MXP
has a 2.5mm 3-pole mini-
jack connector at its right side marked
with a headset symbol. This allows the
user to connect a standard telecommuni-
cations headset to the system.
Headsets with the microphone positioned
in front of the user’s mouth, connected to
the earphone through a rod, tend to give
more echo than earbud headsets with
the microphone attached to the cord.
TANDBERG recommends the Plantronics
MX100 headset (http://www.plantronics.
com, products > mobile).
Note that the maximum outer diameter
of the plug must be 7.0 mm or smaller.
A plug with a bigger outer diameter will
not fit the unit. Alternatively an extension
cord may be used.
Connect your
LAN
(Local Area Network)
here.
If you have a single LAN connec-
tion only and this is in use by your
PC already, connect your PC to the
150
MXP
and the 150
MXP
to the
LAN to let both units have internet
access.
Connect
Power
here.
