Tandberg Data DAT 72, Руководство пользователя

Страница: 26 / 48

Table 5-2 LED sequences for DAT 160, continued
Action required Cause LED Sequence
Unload the tape cartridge. Make sure
that you are using the correct format
cartridge. (See “
Use the correct
media ” on page 31.)
Reload the cartridge. If the Tape LED
still flashes or starts flashing during the
next backup, load a new or known
good cartridge.
If the Tape LED is now off, discard the
'suspect' tape cartridge. If it is still on,
call for service.
The drive
believes the
current tape
or the tape
just ejected is
faulty.
Tape FLASHES.
Load a new cartridge. If the error
persists, power cycle or reset the drive.
If the Drive LED remains on, call for
service.
The drive
mechanism
has detected
an error.
Drive FLASHES.
Insert a cartridge to clear the LED
sequence. If the condition persists, call
for service.
There is a
firmware
download
problem.
Drive, Tape and
Ready FLASH.
LED sequences for the DAT 72 tape drive
There are two LEDs, labeled Tape and Clean. The meaning of different
patterns of LEDs is as follows:
1018932 DAT USB Tape Drives
26
Chapter 5–Operating your tape drive