Tandberg Data DAT 160, Руководство пользователя

Страница: 18 / 58

Figure 2-1 Checking the SCSI ID
1. Determine whether you need to change the SCSI ID from the default
of 3.
2. Change the tape drive's SCSI ID, if necessary.
The SCSI ID is set using jumpers on a set of pins at the rear of the
drive, as shown in figure 3. Use tweezers or small pliers to move the
jumpers to the pattern corresponding to the ID you want. Do not remove
the TP jumper. It should always be set.
Spare jumpers will be attached to the drive. The
drive is supplied with compression enabled. It can
be disabled by removing the compression jumper,
but this is not generally recommended. Note:
Prepare mounting bay
You need one industry-standard, 5¼-inch bay in which to install the DAT
tape drive.
To avoid personal injury or damage to the server or
tape drive, ensure that the server is disconnected Warning
from the mains power supply while you install the
drive.
1018931 DAT SCSI Tape Drives
18
Chapter 2–Installing an internal DAT tape drive