Barcode Reader installation instruction Rev . 1.01
2 / 3
Content of the kit
1 Barcode reader
Required tools
1 Flat-blade screwdriver; small
Installing a Barcode Reader
1. The barcode reader has to be mounted on the rear side of the autoloader, see
figure.
2. Power down the autoloader.
3. Remove the SCSI cable(s) and power cord from the rear panel of the autoloader
and disconnect the power cord from the outlet.
4. Remove the cover plate from the rear panel. Save the screws!!! Save and store
the cover plate; you may use this plate later after removing the barcode reader.
5. Orient the barcode reader in front of the slot. There is only one correct
orientation. Check whether the holes align.
6. Connect the cable to the barcode controller outlet.
7. Attach the barcode reader with the screws (you saved).
8. Reconnect the SCSI cables and power cord to the autoloader.
