Barcode Reader installation instruction Rev . 1.01
3 / 3
Configuration of the Barcode Reader
1. The barcode reader is controlled through the host software.
2. The Operator Panel does not indicate that a barcode reader had been added.
3. The autoloader and host system will sense the presence of the barcode reader.
4. By the next power up, the barcode reader is enabled for scanning.
Barcode labels
The barcode reader can only operate, if barcode labels are present on the tape
cartridges. Please make sure that only the appropriate barcode labels are used; and
fixed to the cassettes within the indicated margin:
•
Labels: Type
•
Margin: The label has to fixed within the cassette deepening opposite of the tape
door
Removing a Barcode Reader
1. Power down the autoloader.
2. Remove the SCSI cable(s) and power cable from the rear panel. Then
disconnect the power cable from the outlet.
3. Unscrew the screws that fix the barcode reader to the rear panel.
4. Unplug the barcode reader connector from the controller outlet.
5. Replace the cover panel to the rear panel.
