- 34 -
4.3 Bar Code Label
The bar code label contains;
･
A volume serial number that you can read.
･
A bar code label that the
Tandberg LTO2 Autoloader
can read.
When
appling a
bar code label
s to a cartridge
position the bar code
label only
in the recessed
label area (see below figure). A bar code label that extends outside of this
recessed area can
cause reading problems in the internal LTO drive or the robotics of the
TD LTO2 Autoloader
.
Sample Bar Code Label on the cartridge
Figure 4-3 Sample Bar Code Label on the Cartridge
Tip
Do not place any type of mark on the white space area at either end of the bar
code. A mark in this area may prevent the
Tandberg LTO2 Autoloader
from
reading the bar
code label.
Using Bar Code Labels Precautions
When
using a bar code labels, please observe the following precautions.
･
Use only
TANDBERG DATA
-supplied bar code labels.
･
Do not re
-
use a bar code label or re
-
apply a used bar code label over an existing label.
･
Before you apply a new bar code label, remove the old label by
gently
pulling it.
･
Remove the bar code label from the label sheet carefully. Do not stretch the bar code
label or cause the edges to curl.
･
Position the bar code label within the recessed label area..
･
Do not place other autoloader readable bar code labels on other surfaces of the
cartridge. They may interfere with the ability of the bar code reader to read the bar
code.
