TX7140 Intelligent Manual Call Point
Installation &Operation Manual
4050100269-Rev1.1-1215
TANDA UK
Specifications are subject to change without prior notice
6
3 Manual Call Point Configuration
3.1 Preparation
The TX7930 handheld programmer is used to configure manual call point soft address. This tool is not
included, must be purchased separately. The programmer is packed with twin 1.5V AA battery and
cable, ready for usage once received.
Program a unique address number for each device according to the project layout before placing
from the Terminal Base.
Warning:
Disconnect the loop connection whilst connecting to the handheld programmer.
3.2 Addressing
1.
Connect the programming cable to Z1 and Z2
terminals (Figure 3). Press
“Power”
to switch on
the unit.
2.
Switch-on the programmer, then press button
“
Write”
or number
“2”
to enter Write
Address
mode (Figure 4).
3.
Input the desire device address value from 1 to
254, and then press
“Write”
to save the new
address (Figure 5).
Note:
If display
“Success”
, means the entered
address is confirmed. If display
“Fail”
,
means
failure to program the address (Figure 6).
4.
Press “
Exit”
key to go back Main Menu. Press “
Power”
key
to switch-off the programmer.
3.3 Read Configuration
1.
Attach the programming cable to Z1 and Z2 terminals of manual call point. Press
“Power”
to
switch on the unit.
2.
Switch-on the programmer, then press button
“Read”
or
“1”
to enter to Read
mode (Figure 7).
The programmer will display the configuration after few seconds (Figure 8).
3.
Press
“Exit”
key to go back Main Menu. Press
“Power”
key to switch off the programmer.
1. Read
2. Write T
3. R/W Config 7
4. Set
Address: 001
Next Address: 002
Success
Address: 001
Fail
Figure 3
Figure 4
Figure 5
Figure 6
