9
English
12
Fig. 6
Installation of cutting attachment guard (Fig. 7)
WARNING
●
Do not start or operate unit unless each
guard is properly assembled to unit.
●
lf unit is operated without a sharp line
limiters, the line will become too long, the
engine will overheat, and engine damage
may occur.
●
Check sharp line limiters surely cut nylon
line when operating.
WARNING
If an incorrect or faulty guard is
fi
tted, this
may cause serious personal injury.
Fig. 7
NOTE
The guard bracket may come already mounted to
the gear case on some models.
Install the cutting attachment guard on drive shaft
tube against angle transmission. Tighten the guard
bracket
fi
rmly so that the cutting attachment guard
does not swing or move down during operation.
Install the cutting attachment guard to the guard
bracket, which also secures the guard to the gear
case using the two guard mounting screws.
CAUTION
Some cutting attachment guards are
equipped with sharp line limiters. Be careful
with handling it.
NOTE
If your unit has guard location label on drive shaft
tube, follow the indication.
Installation of semi-auto cutting head
1. Function
Automatically feeds more nylon cutting line
when it is tapped at low rpm (not greater than
4,500 min
-1
).
Speci
fi
cations
Code No.
Type of
attaching
screw
Direction of
rotation
Size of
attaching
screw
6696454 Female
screw
Counterclockwise M10×P1.25-
LH
6698639
Applicable nylon cord
Cord diameter: 3/32
˝
(
Φ
2.4 mm) Length: 13 ft (4 m)
2. Precautions
○
The case must be securely attached to the cover.
○
Check the cover, case and other components for
cracks or other damage.
○
Check the case and button for wear.
If the wear limit mark (13) on the case is no
longer visible or there is a hole in the bottom (14)
of the button, change the new parts immediately.
(Fig. 8)
13
14
Fig. 8
○
The cutting head must be securely mounted to
the unit’s gear case.
○
For outstanding performance and reliability,
always use Tanaka nylon cutting line. Never
use wire or other materials that could become a
dangerous projectile.
000Book̲TCG24EBSP̲US.indb 9
000Book̲TCG24EBSP̲US.indb 9
2014/03/26 15:11:35
2014/03/26 15:11:35