tams elektronik
!
English
MT-1 | MT-2 | MT-3
11. Check list for troubleshooting
Parts are getting too hot and/or start to smoke.
Disconnect the system from the mains immediately!
Possible cause: one or more components are soldered incorrectly.
à
In case you have mounted the module from a kit, perform a
visual check (
à
section 6.) and if necessary, remedy the faults.
Otherwise send in the module for repair.
The lamp connected for the functional test of the module does not
light.
Possible cause: one or more components are soldered incorrectly.
(MT-1: e.g. D2, MT-2: e.g. D1).
à
Alter the mounting direction.
Possible cause: The lamp is defective.
à
Check the lamp by
connecting it directly to the voltage supply.
MT-2 only: The module does not switch.
Possible cause: The length of time the input is connected to ground
is shorter than the selected time delay.
à
Reduce the time delay or
lengthen the time the input is connected to ground.
Seite 32
Содержание MT-1
