LD-G-14
English
Page 41
!
Connecting the motor
Open the locomotive housing. Locate the position for the decoder.
Disconnect the motor from the rail current collector or the change-over
switch from the motor and rails if you have a locomotive with electronic
change-over switch. The change-over switch is no longer necessary,
you can remove it.
Caution:
The interference suppression devices mounted to the motor or the
connecting wire must not be removed! Motor and interference
suppression devices are one unit. If even one part is removed, it can
cause extreme interference!
Solder the connection to the slider at point X1, and the connection to
the housing to point X2. These two connections can be exchanged
without effecting functionality.
Solder the connections to the motor at the points X11 and X12. In case
the locomotive´s direction of motion does not match the direction of
motion set at the central unit you should swap the connections at the
points X11 and X12.
Connecting the lighting and other accessories
Before connecting the accessories check if the current is below the
maximum permissible value of 1.000 mA. If accessories with a current
of more than 1.000 mA are connected the decoder will be damaged
when put into operation. Please note that the maximum total current
for motor and accessories should not exceed 3.000 mA.
Disconnect any existing diodes in the leads to the lamps.
Connect the lamps and other accessories to the function outputs (X4 to X7)
on the front of the decoder. The assignment of the function outputs to the
function keys can be altered by setting the configuration variables.
If the lamp or the accessory is already connected with one side to
locomotive ground, the connection is complete. If not, connect the
second side of the lamp or the accessory to the return conductor of the
decoder (point X3).
