English
LD-G-10
Page 38
!
Mounting the locomotive decoder
Follow the connection diagram fig. 1.
Connecting the motor
Before mounting the decoder check if the locomotive motor´s current is
below the maximum permissible value of 500 mA. If it is above 500 mA
the decoder is not suitable for mounting in this locomotive. It would be
damaged when put into operation.
Open the locomotive housing. Locate the position for the decoder.
Disconnect the motor from the rail current collector.
Caution:
The interference suppression devices mounted to the motor or the
connecting wire must not be removed! Motor and interference
suppression devices are one unit. If even one part is removed, it can
cause extreme interference!
Solder the red wire to the right rail current collector and the black wire
to the left rail current collector (in direction of motion). Next solder the
grey and the orange wires to the motor. In case the locomotive´s
direction of motion does not match the set direction of motion you have
to swap the motor connections (grey and orange wire).
Connecting the lighting and other accessories
Before connecting the lighting and other accessories check if the
current is below the maximum permissible value of 100 mA. If lightings
or other accessories with a current of more than 100 mA are connected
the decoder will be damaged when put into operation.
Disconnect any existing diodes in the leads to the lamps. Connect the
lamps and other accessories to the function outputs (white or yellow
wires). The assignment of the function outputs to the function keys will
be made when programming the decoder.
