4
(2) ONE-SIDED LAMINATION
LOADING THE FILM
Unpack only the upper rod. Install nylon, BOPP or even thermal film on 1” or 3” core by following an
adapter---film---adapter sequence onto the rod and fit the adapters onto the paper core. Leave equal
lengths of the rod out of each end. Use the guide to position the roll of film then tighten the screw on
the adapter to secure the roll film. Load the rod on the laminator.
*Note: BOPP film is mainly suitable for 1-sided lamination on mounting boards or thick print sheets
as it has a natural tendency to curl even with very little heat. For best results on 1-sided
lamination without mounting, we recommend using nylon film for this application.
THREADING THE FILM
Refer to threading diagram for one side lamination found on the machine’s right side panel. Do not
mistake the reinforcing bar for the idler roller.
1. To thread the film through the “hot rollers” & “pull rollers”, please push the handle forward to
release pressure on all the rollers. Insert the handle pin into the farthest notch to lock the handle in
place.
