Tamerica TCC-1655HC, Руководство по эксплуатации

Страница: 6 / 9

6
3. Turn the power switch on. It will be located at the back
of the machine.
4. Remove the safety shield.
5. Remove the guide table. (see fig. 1)
6. Pull down the top film through the
Idle Bar_Top and
attach it to the bottom roller. (see fig. 2)
7. Pull up the bottom film through the Idle Bar_Bottom
and attach it to the top film of top roller. (see fig. 3)
8. Replace the safety shield and guide plate.
9. Set the temperature and speed.
10. Align the material on the guide table and press the
foot pedal.
11. After the laminated material has passed through the
rollers, press the foot pedal again to stop.
12. Adjust the roller tension by moving the handle lo-
cated on the upper side.
13. Carefully pull out the laminating material in the back
Fig. 1
Fig. 2
Fig. 3
The temperature and speed can be set for your convenience using the memory button. The
machine will arrive with settings from factory but the memory values can be changed from
M1-M2 and COLD for cold laminating.
How to change memory value:
1. Press and hold M1-M2 for 1 second then set-up value.
2. Press up and down for temperature and speed.
3. Press M1-M2 button to save the entry.
ATTENTION
Cold Lamination
TEMPERATURE AND SPEED MEMORY SETTINGS
If the machine is left unattended for 1 hour, the temperature will
go down to 85°C. You can also do this directly by pressing the
StBy button. On the second hour of the machine being left unat-
tended, it will completely turn off automatically.