TallyGenicom 6605, Руководство пользователя

Страница: 141 / 212

Fault Messages
141
<Online, etc...>
Half Speed Mode
No Status message: The
controller samples the
operating temperature of
key components of the
print mechanism. When
higher than normal
temperatures are sensed,
the print speed is
automatically reduced by
50% and the message
sent the LCD. When the
components cool down,
the print speed returns to
100% and the message
clears. No action is required. If the
message appears often, contact
your authorized service
representative.
1
HAM. COIL OPEN* No Hammer Coil Open.
Electrical malfunction of
one or more hammer
coils. Contact your authorized service
representative.
1
HAMMER COIL BAD*
#, #, #, ...etc
No Hammer coil # failed
current test at power up. Contact your authorized service
representative.
1
HAMMER SHORT*
See User Manual
No Electrical malfunction of
one or more hammer
coils. Contact your authorized service
representative.
1
HB NOT INSTALLD* No Hammer Bank Not
Installed. Self-test
routines do not detect
hammer coils at printer
start-up. Contact your authorized service
representative.
1
HMR BANK FAN FLT Yes Sensors cannot detect
current in fan circuit. Check that fan cable is connected.
Check for obstruction of vents and
fan airway; remove any
obstructions. Check for items
beneath the printer blocking cabinet
vents. Power back on the printer. If
this message recurs, contact your
authorized service representative.
1
ILL EXT BUS ACC* No Illegal External Bus
Access. Firmware error
on the controller board. Contact your authorized service
representative.
1
ILL INST ACCSS* No Illegal Instruction
Accessed. Firmware
error on the controller
board. Contact your authorized service
representative.
1
Table 8. LCD Message Troubleshooting Table
Displayed Message
Can User
Correct?
Explanation Solution