TallyGenicom 6600 Series, Руководство по применению

Страница: 126 / 330

126
Chapter 7
Control Sequences
^M - Select Normal Density Block Characters
Selects 60 dots per inch and sets Block Character parameters.
Command ^M(height);(width)NL
Argument
(height) Character Height Multiplier in even numbers in the
range 2-124 (default = 2).
(width) Character Width Multiplier in even numbers in the
range 2-124 (default = 2).
NOTE: Odd numbers can be selected, but they will default to the next lower
even number (5=>4, 7=>6, etc.).
^N - Select New Introducer
Selects a new character as the control sequence introducer where:
Command ^N(?)NL
Argument
(?) Any single graphic character, such as !, @, #, etc.
The default character is ^ (caret). To avoid potential
problems, the new introducer should not be an
alpha-numeric character (not the letters A-Z or the
numbers 0-9).
To print the Introducer character as data, send it twice.
For example, ^ ^ prints ^-.
^R - Relative Cursor Move
Moves the cursor relative to its current position in increments equal to the
current block character height or width.
Command ^R(xrel);(yrel)NL
Argument
(xrel x W) The distance to move horizontally in increments of
0.01 inches, where W is the current width value.
Positive values move the cursor right, and negative
values move it left. Total distance must be in the
range 0-1320 (default = 0).
(yrel x H) The distance to move vertically in increments of
0.01 inches, where H is the current height value.
Positive values move the cursor down, and
negative values move it up. Total distance must be
in the range 0-9999 (default = 0).