TallyGenicom 6306, Руководство по обслуживанию

Страница: 12 / 175

6300 Series Maintenance Manual
6
1.3.3.3 Top of Form Alignment
Top of Form alignment is performed by moving the form with the up/down arrow keys until the
indicator on the tractors lies at the desired position for the top of the first printed line. Pressing the
TOF key at this point retracts paper so that this position on the form is stationed at Top of Form.
1.3.3.4 Supported Form Sizes
Various form sizes are accommodated. Adjusting the tractor positions accommodates the various
form widths. The range of allowable paper/tractor positions are as shown below (dimensions in
inches). In addition to various form sizes the printer also supports various form weights. These
are usually described as single part up to six part forms (original plus five carbons). The
supported form weights are defined more clearly in TallyGenicom specification 608925.
Form Characteristic Minimum Maximum
Forms Width “A”:
With Horizontal Vernier 2.8 18.7
Forms Length “B”
3.0 12.0
Horizontal Forms Adjustment “C”

With Horizontal Vernier and Forms < 17.6 Wide 0.0 1.10

With Horizontal Vernier and Forms > 17.6 Wide 18.7
–
Form Width 1.10
Tractor Hole to Paper Edge (per ISO 2784) “D”
0.208 0.264
1.3.3.5 Horizontal Vernier
The horizontal vernier will provide up to +/- 0.2 inches of horizontal forms travel for adjusting the
horizontal position of the printed output on the page.