TallyGenicom 2265+, Руководство по обслуживанию

Страница: 71 / 190

Testmodes and Troubleshooting Troubleshooting
4-5
„
Check if new options are built in previ-
ously.
Wrong Board Wrong logic board
„
Remove logic board or Assy.
Replace it with correct one.
Wrong Head Wrong Head
mounted
„
Remove head. Replace it with correct
head.
Motor hot Motor overload
„
Let printer cool down.
THS Error
T2280, 2280+ Printhead defective
or Logic defective Please check
„
1. printhead cable
„
2. cable contacts
„
3. replug head into adapter
Use the:
„
Show function to analyse the head
temperature
„
Print function in service menue to
check the coils
Do not forget to adjust the printhead
after substituting head and/or main logic.
Also adjust printhead only in cold state!
If you’re manipulating the printhead (i.e.
plug / unplug the head to solve a contact
problem) run the adjustment procedure
to asure proper function of the sytem.
Each adjustment the new coil values are
stored on the main board.
Check Ribbon
T2265, T2280 Ribbon drive:
carriage moves too
tight The printer checks after 3850 printed
lines if the ribbon drive blocks. In case of
error the printer will switch to hardware
alarm and shows “Check Ribbon” in the
display.
„
Substitute ribbon
„
Check tightness of CR system
Check Ribbon
2265+, 2280+ Ribbon drive:
No Ribbon or
carriage moves too
tight A sensor checks during power on if a rib-
bon exists, and during printing perma-
nently the motion of the ribbon.
If no ribbon is detected (which is also the
case when you use old T2265/80 rib-
bons) or the ribbon is jamming, a mes-
sage "Check Ribbon" will be displayed
and the printer goes offline. It can be set
to online again by pressing the "Online"
key, and will then print one line before
the next "Check Ribbon" message
appears.
„
Substitute ribbon.
Make sure to use the correct ribbon
(ID: 62471)
Error message Cause Removing the error